Description
This is the Hitec D845WP Waterproof Monster Torque Steel Gear Large Scale Servo. The steel D-845WP is part of the D-Series servo line. All Hitec D-Series servos have been designed Hitec's cutting edge, custom engineering. Combining industry leading high-resolution, state-of-the-art ultra-response technology with a 32-bit MCU and 12-bit ADC for unprecedented programmability and flexibility, these servos deliver significantly smoother movement.
The speedy, powerful line operates on a wide 4.8 ~ 8.4 voltage range, allowing use with any common battery chemistry without the need for adapters or regulators. Featuring a 15 tooth HD output spline with 3mm hex screw, each D-Series servo brings monster performance never known before in the market.
NOTE: Losi Desert Buggy XL applications will require shimming at the servo or the servo tray, to raise the servo high enough to clear the chassis.
Features:
- Programmable PWM Digital Amplifier
- 32-Bit MCU with 12-Bit ADC Circuitry
- 4096 Resolution
- 1M Cycle Long Life Potentiometer
- Wide Operating Voltage (4.8 ~ 8.4 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- 15-Tooth 8mm Output Spline
- Coreless Metal Brush Motors
- Nylon Reinforced Plastic Upper and Lower Case
- Diamond Cut Aluminum Heat Sink Center Case
- IPD 67 Rated Water Resistant and Waterproof Proof Case
Programmable Functions:
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Overload Protection
- Data Save / Load
- Program Reset
Accessories:
- Steel Gear Set
- Metal / Plastic 1st Gear Set
- Plastic / Aluminum Case Set
Specifications:
Operating Voltage Range (Volts DC): 4.8V ~ 6.0V ~ 7.4VSpeed (Second @ 60°): 0.26 ~ 0.21 ~ 0.17Maximum Torque Range oz. / in.: 454 ~ 566 ~ 698Maximum Torque Range kg. / cm.: 32.5 ~ 40.5 ~ 50.0Current Draw at Idle: 30 mANo Load Operating Current Draw: 1,600 mAStall Current Draw: 10,000 mADead Band Width: 2 µsDimensions (Inches): 2.59 x 1.26 x 2.44Dimensions (Metric): 66.0 x 32.0 x 62.0Weight (Ounces): 8.0Weight (Gram): 227.0Circuit Type: 32bit Programable DigitalMotor Type: 5 Poles Cored Metal BrushGear Material: SteelBearing Type: Dual Ball BearingOutput Shaft (type / Ømm): 15T 8mmCase Material: Plastic / AluminumDust / Water Resistance: IP 67Connector Gauge (AWG) / Strand Count: 20 / 80Limited Warranty:Hitec Servo Warranty: Each Hitec servo is backed by a limited two-year warranty from the date of purchase. Hitec RCD USA, INC. shall REPAIR OR REPLACE, at Hitec RCD, INC.
